If you don't have Internet connectivity on the machine you're using to install and configure Security Analysis Solution (SAS), then follow the instructions in this document to get up and running.
Errors during
...
initial configuration
When you install SAS, the initial configuration starts a number of download tasks. These will fail on a machine that is not connected to the Internet, resulting in log errors like the following:
...
There are also a number of SCAP Data Sources data sources that are registered by default. You must download these on a machine that is connected to the Internet, copy them to the correct folders on the AMS, and then re-run the registration tasks that failed during the initial configuration as described previously.
...
If downloading the content manually, get the content (typically .zip files) from the locations specified above and carry to the AMS Then TMS. Then unzip to the %ProgramData%\Arellia\ScapContent. The zipped content should will create its own folder under the ScapContent folder and place any files and sub-folders in that directory.
...
| Tip | ||
|---|---|---|
| ||
Most content comes from external sites to Arellia; typically nist.gov. |
...
The checklist and some of the CVE data comes from portal.arellia.com. |
...
This can be seen by searching arellia-checklist-1.4.xml for portal.arellia.com. |
- Re-run each of the "XXX Update tasks" by right clicking on each of the failed task runs and choosing Start Now. There are 10 of these tasks to run. See the following screen shot showing where these tasks can be found.
...
- Use the SCAP Data Source Update Summary report to confirm they have been registered. At the time of writing this there are 16 data sources.
- The following is a direct link to the report - modify the host name as required.
- http://localhost/Ams/SecurityManager#/Reports/56e76749-b12e-45f8-af58-05a10e9d7721
Importing Profiles
Running the console and choosing the Profiles tab will take you to the Download Profiles view. It will look like the following:
...