/
Perform local user inventory
Perform local user inventory
After the Local Security Agent has been installed, the solution performs a local user inventory. This inventory is gathered by the Local User inventory policy, which is enabled by default. You do not need to do anything for this policy to run. However, you may want to view this policy and its settings.
To view the Local User inventory policy, do the following steps:
- Click the Configuration tab.
- In the left pane, select Configuration > Solutions Settings > Security Management > Local Security > Windows > Local Security Agent Configuration > Local User Inventory Policy. Take note of the collection this policy applies to and the interval it is set to run. You can change the interval as needed. (If you make changes click Apply.)
, multiple selections available,
Related content
Local User Inventory
Local User Inventory
More like this
Local Security agent configuration
Local Security agent configuration
More like this
Windows Service Inventory Policy
Windows Service Inventory Policy
More like this
Local user inventory
Local user inventory
More like this
Windows service inventory policy
Windows service inventory policy
More like this
Install the Local Security agent on computers
Install the Local Security agent on computers
More like this